Maintain Your Dremel 3D Idea Builder

 

UNCLOGGING THE EXTRUDER

Use the unclogging tool to clean the extruder and unclog built up filament.
  1. Wait for extruder to heat up insert the unclog tool into the extruder intake (top).
  2. Clogged debris will be pushed down and will extrude from the extruder tip.

 

CLEANING THE EXTERIOR

Clean the 3D20’s exterior with a lint free cloth. Clear the outer surfaces of any debris that is visible.

To avoid damaging your Dremel 3D20 do not use water, chemicals or other cleaners on the 3D20.

 

CLEANING THE EXTRUDER TIP

CAUTION: Use extra care not to damage the extruder tip when clearing debris. Dremel 3D20 will not work properly with damaged extruder tip and will require replacement.

WARNING: Do not touch the extruder tip during Dremel 3D20 operation or until it has cooled down to 60°C (140°F). Contact with the extruder tip during or shortly after operation may result in personal injury.

Using small needle nose pliers, pull away any plastic debris from the extruder tip.

If the debris is stubborn, the extruder may need to be heated to make the debris soft enough to remove.

 

CLEANING THE TOUCH SCREEN

Wipe the touch screen with the soft, lint-free cloth. Do not spray cleaners on the touch screen.